Water Temperature Control—Recirculation Systems—Digital

DMC1

Model DMC1 features a single DRV80 pre-piped and pressure tested complete with isolation valves, strainers, check valves, thermometers and pressure gauges along with an optionally selected system circulating pump (DMC12).The Brain Model DRV80 is a fully digital recirculating valve (DRV) for "point of source" or mechanical room based installation. DRV80 is designed specifically to be the primary water temperature controller in a continuously pumped recirculating hot water system.

Operational Specifications

The enhanced accuracy possible with DRV80 digital technology, combined with its data input/output communication capability equals:

• Accurate control of blended water drawn from the system at a point of use typically within +/-2°F at draw off points a minimum of 5m downstream of mixing valve during consistent system demand periods
• Operational water pressure of 10 -150 psig
• Minimum valve inlet to outlet temperature requirement (system recirculation temperature loss) of 2°F
• Automatic shutoff of hot water flow upon cold water inlet supply failure
• Automatic shutoff of hot water flow in the event of a power failure
• Maintain a consistent system "idling" temperature and control temperature creep without the use of a manual throttling device or balance valve.
• System shall not require a temperature activated pump shut-off device (aquastat).
• Programmable set point range of 81-158°F (29-71°C) plus full hot/full cold
• Ability to thermally disinfect at recommended temperatures
• Programmable 1st level high/low temp alarm display
• Programmable temperature error level for safety shutdown